Solar Roofing or Traditional Solar Panels – Which Should You Choose?
Don’t get me wrong. We’re not anti-PV. Quite the contrary. We install PV as well as solar thermal systems. On a personal note, we lived completely off-grid and used two small PV systems to supply electricity for our home and an outbuilding for three years before moving to the Wausau area. It was a wonderful experience in many ways and we plan to install PV in some capacity on our new home once we’ve gotten that far in the renovation process.
Visit Performance Energy, Inc.
Tags: installing solar, photovoltaics, PV, solar, solar installation, solar panels, solar roof, solar roofing, Wisconsin
Installing solar thermal panels for space heating
Yesterday was a busy Sunday. We were supposed to install thermal panels for a solar space heating job last Friday, but pouring rain and a very steep metal roof don’t equate to a safety green light. Since the roofing crew was willing to come in on Sunday, we decided to postpone.
The weather Sunday was a mixed blessing. We did experience intermittent light rain, but on the bright side – it wasn’t bright! Solar hot water installers pray for overcast conditions on installation days. Otherwise the thermal panels heat up in the sun too much and you have to find some way to cover them.
This particular system is going onto a new home being built in rural Marathon. The home is designed for extreme thermal efficiency. We’ll tell you more about it in future posts.
Yesterday we were able to get two of the four panels up on the roof before the rain cut loose again and brought work to a standstill. You can see more photos of the solar panel installation on our Facebook page. Also, stay tuned – videos ahead!
Visit our website for more information on solar hot water.
Tags: Marathon, solar collector, solar contractor, solar hot water, solar installation, solar installer, solar panels, solar space heating, solar thermal
A Successful Solar Hot Water Installation

We filled Al Henrick’s solar loop on Saturday night. Night is best to prevent steam from forming. The big delay was running the electric power to the pumps from a remote PV panel. Today was the first sunny day after filling and the system worked flawlessly. By the time I left around 1:30, standard time not daylight time, the tank was around 120 degrees F. The coldest water off the bottom of the tank was 114 degrees, and the heat exchanger was returning 124 degree water to the center of the tank. This was a cold start since the system had never run before, and the starting temperature was around 55-58 degrees.
It was interesting to listen to the pumps slow down and speed up as clouds reduced the output of the PV panel and then moved away. I worked on the insulation for a little while, and the tank rose from 84 degrees when I arrived around 11:00 standard time to the 114 degrees I mentioned earlier by the time I left. The storage tank holds 105 gallons, so this is a substantial rise in temperature. All we need to do now is finish up insulating the elbows and other fittings, and then install jacketing on the exterior insulation to protect it from UV rays and we are DONE!
Dan Michelsen

